slide 1:

For More Information – Visit link below: Product Version Up to Date products reliable and verifed. Questions and Answers in PDF Format. “200-125 Exam Dumps” Cisco Certified Network Associate https://www.realexamdumps.com/cisco/ 200-125-practice-test.html

slide 2:

Queston: 1 Refer to the exhibit. At the end of an RSTP electon process which access layer switch port will assume the discarding role A. Switch3 port Gi0/2 B. Switch3 port Gi0/1 C. Swrtch4 port fa0/11 D. Switch3 porta0/12 E. Switch3 port fa0/1 F. Swrtch4 port fa0/2 Answer: C MAC of Switch3 is smaller than that of Switch4 so both ports of Switch3 will be in forwarding state. The alternatve port will surely belong to Switch4. Switch4 will need to block one of its ports to avoid a bridging loop between the two switches. But how does Switch4 select its blocked port Well the answer is based on the BPDUs it receives from Switch3. A BPDU is superior than another if it has: 1. A lower Root Bridge ID 2. A lower path cost to the Root 3. A lower Sending Bridge ID 4. A lower Sending Port ID These four parameters are examined in order. In this specifc case all the BPDUs sent by Switch3 have the same Root Bridge ID the same path cost to the Root and the same Sending Bridge ID. The only parameter lef to select the best one is the Sending Port ID Port ID port priority + port index. In this case the port priorites are equal because they use the default value so Switch4 will compare port index values which are unique to each port on the switch and because Fa0/12 is inferior to Fa0/1 Switch4 will select the port connected with Fa0/1 of Switch3 as its root port and block the other port - Port fa0/11 of Switch4 will be blocked discarding role Queston: 2 DRAG DROP Drag and drop the protocols from the lef onto the correct IP trafc types on the right. https://www.realexamdumps.com/cisco/200-125-practice-test.html

slide 3:

Answer: HTTP SMTP SNHP VoIP Queston: 3 DRAG DROP Drag the cable type on the lef to the purpose for which is it best suited on the right. Not all optons are used. Answer: Switch to router : rollover Switch to switch : crossover PM Com port: 9 - 25 pin Queston: 4 A router has learned three possible routes that could be used to reach a destnaton network One route is from EIGRP and has a composite metric of 07104371. Another route is from OSPF with a metric of 782 The last is from RIPv2 and has a metric of 4 Which route or routes will the router install in the routng table https://www.realexamdumps.com/cisco/200-125-practice-test.html

slide 4:

A. the EIGRP route B. the OSPF route C. the RIPv2 route D. all three routes E. the OSPF and RIPv2 routes Answer: A Queston: 5 If you confgure syslog messages without specifying the logging trap level which log messages will the router send A. error conditons only B. warning and error conditons only C. normal but signifcant conditons only D. all levels except debugging E. informatonal messages only Answer: E Queston: 6 Which feature facilitates the tagging of frames on a specifc VLAN A. routng B. hairpinning C. switching D. encapsulaton Answer: D Queston: 7 Which WAN topology provides a direct connecton from each site to all other sites on the network A. single-homed B. full mesh C. point-to-point D. hub-and-spoke https://www.realexamdumps.com/cisco/200-125-practice-test.html

slide 5:

Answer: B Queston: 8 Which two optons are primary responsibilites of the APIC-EM controller Choose two. A. It automates network actons between diferent device types. B. It provides robust asset management. C. It tracks license usage and Cisco IOS versions. D. It automates network actons between legacy equipment. E. It makes network functons programmable. Answer: A E htp://www.cisco.com/c/en/us/products/cloud-systems-management/applicaton-policy-infrastructure- controllerenterprise- module/index.html Automate network confguraton and setup Deploy network devices faster Automate device deployment and provisioning across the enterprise. Provide a programmable network Enable developers to create new applicatons that use the network to fuel business growth. Queston: 9 Which command can you enter to troubleshoot the failure of address assignments A. show ip dhcp pool B. show ip dhcp database C. show ip dhcp import D. clear ip dhcp server statstcs Answer: A Queston: 10 Which three optons are the major components of a network virtualizaton architecture Choose three. A. virtual network services B. authentcaton services C. network access control D. network resilience https://www.realexamdumps.com/cisco/200-125-practice-test.html

slide 6:

Thank You for Trying Our Product For More Information – Visit link below: Powered b y TCPDF www.tcpdf.org https://www.realexamdumps.com Authentic Tips Of VCS-411 Exam Dumps With 20 Exclusive Discount Offered By RealExamDumps.com