slide 1:

AVI POP UP WASTE Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors. All ABI Products are designed in Australia. Copyright ABI Interiors 2019. WWW.ABIINTERIORS.COM.AU SPECIFICATIONS RECOMMENDED USE INSTALLATION OVERFLOW WARRANTY No Structure: 10 years | Finish: 5 years Domestic Suits 40mm Trap 5-60 M6 45 G1 1 2 Ø63 40mm suits 40mm trap 1 2 3 Disassemble the components of the pop-up waste. Place the lower section of the pop-up with silicon washer underneath the basin and align the the two components. Unscrew brass mechanism to fix with the provided Fix and tighten the mechanism component into the top and screw on the pop-up lid Note: This product must be installed by a licensed trade This is a general installation guide - there are many factors that are involved that can alter the installation method. INSTALLATION GUIDE Plumb into connection. Test by running water through the waste and pushing plug up and down. 2 Place the top section along with threaded bolt and white washer into the basin hole