Reverse Osmosis Water Filtration

Category: Entertainment

Presentation Description

No description available.


Presentation Transcript

Reverse Osmosis Water Filtration : 

Reverse Osmosis Water Filtration i was wondering about the omnihousewatersystem house filter we just moved where our water is from a well right now the water smells so bad coming out of the taps i can barely shower i wont even do my dishes in it i noticed outside attached to the well there are two cylinders that say omni house but there is no filter inside them and they have brown algae looking stuff in them i was wondering where to get filters how much they cost and if that filtration system is meant for wells Pour some bleach in the filter housing and let it set for 30 mins. and run your water for a while, all the faucets shower toilet and let the bleach clean out each line. Write down the model number and go to Lowes or Walmart and get a good sediment filter for the first one coming out of the well and a charcoal filter for the second one, spend $50 or so to have a new one on hand for when you need, put it in a Ziploc bag and tie it to the pipe somewhere.

Slide 2: 

work for a bottled water company which also installs filtration systems ranging from whole-house systems and point-of-entry to point of use to undercounter units. A customer recently asked about a whole-house system which would be located underground between his home and the city water main, however, even on a Web search we’ve been unable to find anything like this, and our operations manager cannot recall seeing anything that meets these specifications at any of the trade shows or training sessions he has attended. Is there anyone out there who either has a system like this or works with systems like these, and could point me in the right direction? The man actually said his neighbor has one…but we think he may be mistaken as to what his neighbor has.

Slide 3: 

An electrically operated water pump is the prime motivator in recirculating the water from the pool. Water is forced through a filter and then returned to the pool. A typical pool pump uses 500 watts to 2,000 watts. Commercial and public pool pumps usually run 24 hours a day for the entire operating season of the pool. Residential pool pumps are typical run for 4 hours per day in winter (when the pool is not in use) and up to 24 hours in summer. To save electricity costs most people run for between 6 hours and 12 hours in summer with the pump being controlled by an electronic timer. Commercial pools require a minimum 4 hour circulation of the total water volume.

Slide 4: 

Some pool pumps have two motor speeds to reduce power consumption at times when full power is not needed. Other pump manufacturers (typically Italian or other European) have redesigned their units to use a smaller electric motor with heavier windings, therefore consuming less energy, to power a larger pump impeller. Variable-speed pumps reduce power consumption even more. These pumps run slowly 24 hours a day. The slow speed typically cleans better because smaller particles can be filtered. At the slow speed, minimal resistance in the pipes reduces the energy needed to move the water.

Slide 5: 

A pressure-fed filter is typically placed in line immediately after the water pump. The filter typically contains a media such as graded sand (called ‘14/24 Filter Media’ in the UK system of grading the size of sand by sifting through a fine brass-wire mesh of 14 to the inch to 24 to the inch). A pressure fed sand filter is termed a ‘High Rate’ sand filter, and will generally filter turbid water down to 10 micrometers in size. The rapid sand filter type are periodically ‘back washed’ as contaminants reduce water flow and increase back pressure. Indicated by a pressure gauge on the pressure side of the filter reaching into the ‘red line’ area, the pool owner is alerted to the need to ‘backwash’ the unit. The sand in the filter will typically last five to seven years before all the “rough edges” are worn off and the more tightly packed sand no longer works as intended. Recommended filtration for public/commercial pools are 1 ton sand per 100,000 liters water.

authorStream Live Help