Common Problems in a Fridge Freezer

Views:
 
     
 

Presentation Description

The refrigerator is the most commonly used home appliance in our kitchen. If the Refrigerator got repaired, it affects the more on daily activities. That's why we are here to solve Refrigerator repairs at your doorstep. Call: +91-88866 88666 refrigerator repairman near me Hyderabad. https://www.doorstephub.com/refrigerator-service-repair/Hyderabad

Comments

Presentation Transcript

slide 1:

Common Problems in a Fridge Freezer Refrigerator is the most commonly used home appliance in our kitchen. It keeps the food fresh for a long time by cooling them. If the freezer doesn’t works properly then it would affect a lot. So here I would like to discuss how to diagnose a fault in a frost-free freezer or fridge freezer. Now generally discuss most faults in fridges and freezers are very simple to diagnose and actually just involve replacing the faulty parts like the door seal or the lamp. Now they actually develop frost but you cant see that because its concealed behind the cover in the back. To give you a better idea of whats going on I am going to discuss briefly. Firstly remove the shelves and icebox as well as the back cover so we can see the compartments inside. Here in the back we have an evaporator now this is essentially a radiator that is cooled by liquefied gas being pumped through it from a compressor.

slide 2:

The fan at the top draws air into the appliance and then blows air across the evaporator because the evaporator is cool. It cools the evaporator the temperature and that air is then distributed around the cavity by the fan freezing anything. In some of the refrigerator model some of the air is also ducted into the fridge compartment and the flow of that cool air is controlled by a motorized flap and it goes in through duct up at the top then travels down through the fridge and returns through this duct at the bottom. Now when you opened the freezer door the cool air inside falls out and its replaced by the warm moist air in the room. The moisture from the air settles on the cool evaporator where it cools so much that it turns to frost. Over time a build-up of that frost is going to affect the airflow. So for that reason there is an element fitted underneath the evaporator which turns on round about every 16 hours of the motor running and for a little while heats of the frost up so that it can melt and drain away through the hole in the bottom and out to the back. Common Faults Now the most common faults that occur in a frost-free appliance are the build-up of ice on the evaporator. • If ice builds up then obviously its going to affect the airflow and that means the temperature is never going to get low enough. Now the cause of that could be a faulty heater a faulty sensor or a fuse or a fault with a control board or timer. • Now to test the heater you need to trace its connections to the plug and disconnect the heater from the plug and test its resistance with a multi meter. Look for the reading somewhere between two hundred and three hundred ohms. So obviously any reading outside that would indicate the presence of a fault and you need to replace the heater. • You may also have a fault in the sensor or the fuse which is located near to the heater. Now working sensor or fuse should get a reading of a short circuit for the fuse or less than a couple of ohms and again any reading was different to that would indicate the presence of a fault. • There may be sensors around to the evaporator and for that you should be getting a reading of anywhere between 2000 and 40000 ohms any reading outside of that which shows that there is a fault. • Once you have checked all of these areas than the most likely sources that have a fault are the control board or timer and you need to get those replaced. If you have any other issues with your refrigerator then consult the refrigerator repairman near me Hyderabad. Call: +91-88866 88666.

authorStream Live Help