Problem11-Arm&Nut

Download
Share  Add to  Flag Embed
Uploaded from authorPOINTLite
Views:
 
Category: Entertainment
     
 
License:   All Rights Reserved

Presentation Description

No description available.

Comments

Presentation Transcript

Slide 1: 

OBJECTIVE: is to teach you how to cut & apply threads; & insert views into New Titleblock (idw) Problem #11: A-Arm (50 pts) B-Nut (50 pts)

Slide 2: 

Make sure you Save As Your “U” Drive Inventor Folder P11-A-Arm & P11-B-Nut

Slide 3: 

Make a new Standard Metric IPT

Slide 4: 

Snap = 10, Grid 1 & 1

Slide 5: 

Draw to the following dimensions.

Slide 6: 

Extrude it 13mm so that it looks something like this.

Slide 7: 

Select & sketch on this edge the following.

Slide 8: 

Draw the following to these dimensions.

Slide 9: 

Make it look like this

Slide 10: 

Extrude/Cut to match.

Slide 11: 

Should look something like this.

Slide 12: 

Select this surface and draw the following to get the center.

Slide 13: 

Draw 13 dia circle

Slide 14: 

Extrude the circle 51mm out.

Slide 15: 

Should look something like this

Slide 16: 

Chamfer 3D 1mm the circle shaft

Slide 17: 

Should look something like this

Slide 18: 

Select Thread & select the shaft as the face

Slide 19: 

Pick Selection, ANSI Metric M Profile, Size 14, MX14x2, & 6g

Slide 20: 

Should look something like this

Slide 21: 

Save it as 11A-Arm to Your “U” drive & 11B-Nut Metric (IPT)

Slide 24: 

Extrude it 10mm

Slide 25: 

3mm Radius Fillet top & bottom

Slide 32: 

Save it as 11B-Nut to Your “U” drive & 11Arm&Nut- Metric Assembly

Slide 34: 

Click on the Assemble button, Component tab, go find the 11A-Arm Insert it into the assembly

Slide 35: 

Repeat for the 11B-Nut part

Slide 36: 

Click on the Assemble button, Position button, Constrain

Slide 37: 

Select the Arm’s shaft 1st, When you do you will see the new center line

Slide 38: 

Then select the 11B-Nut & “tada” they are assembled!

Slide 39: 

Make sure you Save As Your “U” Drive Inventor Folder P11-Arm & Nut Assembly

Slide 40: 

Next, ADD the Tuner (ipt) to the Into a new Title block (idw)

Slide 42: 

Right click your mouse On the Sheet 1 tab Then “Edit Sheet”

Slide 43: 

Change the sheet size To “D”

Slide 44: 

Add the parts & assembly Views scale = 2:1 & Isometric scale = 2:1 Assembly of both Isometirc scale = 4:1

Slide 45: 

Should look like this. Now Annotate or add dimensions to match

Slide 49: 

Change the iProporties so That the Titleblock Info. matches

Slide 50: 

Make sure you Save As Your “U” Drive Inventor Folder P11-Arm & Nut Assembly Drawing

Slide 51: 

Print the drawing as a PDF Upload the DRAWING to Moodle for grading.