Problem12-Arm-Sectional

Download
Share  Add to  Flag Embed
Uploaded from authorPOINTLite
Views:
 
Category: Education
     
 
License:   All Rights Reserved

Presentation Description

No description available.

Comments

Presentation Transcript

Slide 1: 

OBJECTIVE: is to teach you how to 3D Extrude; insert views into New Titleblock; create sectional views (idw) Problem #12: Arm (100 pts)

Slide 2: 

Make sure you Save As Your “U” Drive Inventor Folder P12-Arm-Sectional

Slide 3: 

Written by Reagan Blake and Gary Rodgers

Slide 4: 

Make a new Standard ENGLISH IPT

Slide 5: 

Snap = .125, Grid 1 & 8

Slide 6: 

You will begin by carefully observing the next drawing.

Slide 7: 


Slide 8: 

You will begin by drawing the top view to match.

Slide 9: 

Extrude the entire object .5".

Slide 10: 

Select this face.

Slide 11: 

Create a New Sketch

Slide 12: 

Draw this line again.

Slide 13: 

Extrude this part 2".

Slide 14: 

Rotate the part so you can Select the bottom side & Add a new sketch to it.

Slide 15: 

Draw the circles again using the same size and center point.

Slide 16: 

Extrude this part 1.25".

Slide 17: 

Revolve to see this face. Create a New Sketch

Slide 18: 

Draw lines to place the hole. Insert a "Point, Hole Center" at the intersection.

Slide 19: 

Create a hole at the center point, .75 Dia & Through All.

Slide 20: 

Rotate and select these two lines for a .25 fillet.

Slide 21: 

Rotate and select this line for a .25 fillet.

Slide 22: 

Make sure you Save As Your “U” Drive Inventor Folder P12-Arm Sectional

Slide 23: 

Next, ADD the Tuner (ipt) to the Into a new Title block (idw)

Slide 24: 

Add these 2 views to the Titleblock Given

Slide 25: 

Select the Front view.

Slide 26: 

Click in Section view & draw a line to match. Right click & select continue.

Slide 27: 

Draw the lines so that you See this now.

Slide 28: 

Create a Full section View to match this

Slide 29: 

Create an projected Isometric view & Dimension to match this.

Slide 30: 

Make sure you Save As Your “U” Drive Inventor Folder P12-Arm Sectional Drawing

Slide 31: 

Print the drawing as a PDF Upload the DRAWING to Moodle for grading.