Session 4_D12655.10_Guideline_Hands-On-Session-Day2

Hands-On SessionDay 2 Systems and Sales : 

Hands-On SessionDay 2 Systems and Sales

Hands-On Session : 

2 Hands-On Session Group A: Video features Group B: Audio features Group C: Simple Fault finding & Software Upgrades TANDBERG TRAINING D12655 Rev 1.0

Hands-On Session: Video features (1) : 

3 Hands-On Session: Video features (1) Discuss difference in video/audio quality on 3M and 128K Set up call on 192K, notice difference of quality between 4xCIF and CIF & SVGA Simulate ’downspeed’ to 128K by pulling out the correct ISDN line. Install Doc.cam. on S-Video input (verify that naming is correct)

Hands-On Session: Video features (2) : 

4 Hands-On Session: Video features (2) Install an additional WAVE camera How many cameras can be connected to a T6000 and controlled via the remote control? XVGA Discuss the purpose of XVGA output Set XVGA out to Main-monitor. Test & Try.

Hands-On Session: Audio features (1) : 

5 Hands-On Session: Audio features (1) Make a preset where Mic1 if OFF and rest of audio inputs are ON Change audio algorithms in a call and spot the difference in quality Set up system for Voice tracking by using 2 (or 3) microphones Demonstrate ’Noise Reduction’ for a customer

Hands-On Session: Audio features (2) : 

6 Hands-On Session: Audio features (2) ’VCR ducking’- What is it and what’s the usage? Test the various Audio Outputs. If necessary, use the Technical Manual to find out why only Audio Out 1 is used for main speaker. Show how to set local microphone OFF for all incoming calls What is the Audio Science Microphone?

Hands-On Session: Audio features : 

7 Hands-On Session: Audio features Audio AGC ’Automatic Gain Control’ NR ’Noise Reduction’ Echo control Presets stored with audio settings Audio levelling/ Audio mixer

Hands-On Session: VGA interface and Presets : 

8 Hands-On Session: VGA interface and Presets VGA in/out The ’Tracker’ Voice activated WAVE-camera

Hands-On Session: Simple Fault finding & Upgrades (1) : 

9 Hands-On Session: Simple Fault finding & Upgrades (1) Use the loop-back feature between two TANDBERG systems (ISDN call!) Set up a call from the web browser Get all parameters from the remote system by using Telnet (ISDN call!) Use Telnet to find the HW number and SW version of both the remote system and your local system

Hands-On Session: Simple Fault finding & Upgrades (2) : 

10 Hands-On Session: Simple Fault finding & Upgrades (2) Call settings Understand the whole call setting menu (e.g. Network profiles, MCU calls OFF) How to restore all defaults? Learn how to do a Tracing ISDN/H221/syslog/event.log

Hands-On Session: Simple Fault finding & Upgrades (3) : 

11 Hands-On Session: Simple Fault finding & Upgrades (3) Notes below..

Hands-On Session: Simple Fault finding & Upgrades (4) : 

12 Hands-On Session: Simple Fault finding & Upgrades (4) Notes below..