N10-006 Exam Questions Answers

Category: Education

Presentation Description

Examsleader provide you N10-006 real exam questions with correct answers and cover with full course objective. We assure you will pass your exam in first attempt.For further detail visit us. http://www.examsleader.com/N10-006-exam.html


Presentation Transcript

slide 2:

Examsleader provides you real CompTIA N10-006 Exam Questions with correct answers

slide 3:

 Cover full course objective  N10-006 recommended by Experts  N10-006 free Future updates  Money Back Assurance  Passing Guarantee http://www.examsleader.com/N10-006-exam.html

slide 4:


slide 5:

http://www.examsleader.com/N10-006-exam.html A technician needs to limit the amount of broadcast traffic on a network and allow different segments to communicate with each other. Which of the following options would satisfy these requirements A. Add a router and enable OSPF. B. Add a layer 3 switch and create a VLAN. C. Add a bridge between two switches. D. Add a firewall and implement proper ACL.

slide 6:

http://www.examsleader.com/N10-006-exam.html The network install is failing redundancy testing at the MDF. The traffic being transported is a mixture of multicast and unicast signals. Which of the following would BEST handle the rerouting caused by the disruption of service A. Layer 3 switch B. Proxy server C. Layer 2 switch D. Smart hub.

slide 7:

http://www.examsleader.com/N10-006-exam.html A technician needs to set aside addresses in a DHCP pool so that certain servers always receive the same address. Which of the following should be configured A. Leases B. Helper addresses C. Scopes D. Reservations

slide 8:

http://www.examsleader.com/N10-006-exam.html A technician just completed a new external website and setup access rules in the firewall. After some testing only users outside the internal network can reach the site. The website responds to a ping from the internal network and resolves the proper public address. Which of the following could the technician do to fix this issue while causing internal users to route to the website using an internal address A. Configure NAT on the firewall B. Implement a split horizon DNS C. Place the server in the DMZ D. Adjust the proper internal ACL

slide 9:

http://www.examsleader.com/N10-006-exam.html When configuring a new server a technician requests that an MX record be created in DNS for the new server but the record was not entered properly. Which of the following was MOST likely installed that required an MX record to function properly A. Load balancer B. FTP server C. Firewall DMZ D. Mail server

slide 10:

http://www.examsleader.com/N10-006-exam.html Which of the following protocols uses label-switching routers and label- edge routers to forward traffic A. BGP B. OSPF C. IS-IS D. MPLS

slide 11:

http://www.examsleader.com/N10-006-exam.html Which of the following is MOST likely to use an RJ-11 connector to connect a computer to an ISP using a POTS line A. Multilayer switch B. Access point C. Analog modem D. DOCSIS modem

slide 12:

http://www.examsleader.com/N10-006-exam.html An administrator notices an unused cable behind a cabinet that is terminated with a DB-9 connector. Which of the following protocols was MOST likely used on this cable A. RS-232 B. 802.3 C. ATM D. Token ring

slide 13:

http://www.examsleader.com/N10-006-exam.html Which of the following connection types is used to terminate DS3 connections in a telecommunications facility A. 66 block B. BNC C. F-connector D. RJ-11

slide 14:

http://www.examsleader.com/N10-006-exam.html An F-connector is used on which of the following types of cabling A. CAT3 B. Single mode fiber C. CAT5 D. RG6

slide 15:


authorStream Live Help