roots innursery

Tree Roots in the Nursery: 

Tree Roots in the Nursery By Edward F. Gilman, professor Department of Environmental Horticulture University of Florida http://hort.ufl.edu/woody/planting

Topics covered in this presentation: 

Topics covered in this presentation Introduction to tree root growth Root growth in containers Root growth in field grown trees Root growth in fabric bags

Introduction to root growth: 

Introduction to root growth Roots are generally not as deep as you might think Some trees have deep roots under the trunk and canopy The majority of roots are in the top two feet Roots are typically above the water table and above any hardpan or compacted soil layers Many of the small diameter roots are in the top 12 inches

Topics covered in this presentation: 

Topics covered in this presentation Introduction to tree root growth Root growth in containers Root growth in field grown trees Root growth in fabric bags

Root growth in a container nursery : 

Root growth in a container nursery Roots in their natural environment grow to well beyond the edge of the branches Without specially designed containers, severe root defects can develop as roots are deflected by container walls Some of these specially designed containers will be illustrated and described here

Many roots are circling the container wall: 

Many roots are circling the container wall Maple planted from a 1 gal. container into this 15 gal. container 15 months ago It is past time to move this tree to a larger container or plant it Slice the root ball from top to bottom about 1 in. deep in four places before planting

Poor root system: 

Poor root system Circling root 3 years after planting a 1 gal. liner It was much smaller 3 years earlier and should have been cut then The 1 gal. liner was also planted too deep

Large girdling root: 

Large girdling root This large root (arrow) was circling the one gallon container 18 months ago Tree was potted into a larger container without slicing the circling root Now the tree is a cull

Container type examples: 

Container type examples Shown above from left to right: wood box with Spin OutTM, wood box, low profile plastic, plastic with Spin OutTM, plastic, low profile air root pruned (Accelerator), standard air root pruned (Accelerator)

Trees from different container types : 

Trees from different container types These red maples were grown in seven different 15-gallon container types; note the varying shapes of the root balls resulting from the different containers The tops grew identically as they have in many other demonstrations and studies Roots on the wooden boxes, air root pruned containers, Spin OutTM treated containers, and low profile containers had less circling roots than trees in the standard black plastic containers

No roots on outside of root ball: 

No roots on outside of root ball This root ball is firm and does not fall apart There are very few circling roots These two factors combined indicate good quality This was accomplished by growing in a container treated with Spin OutTM

Many roots inside but few on the edge of root ball indicate quality: 

Many roots inside but few on the edge of root ball indicate quality The media has been partially removed on this 15 gal. container red maple to expose the roots This high quality root ball has many small diameter roots There were few circling roots on the outside edge of the root ball

Air root pruning containers reduce number of circling roots: 

Air root pruning containers reduce number of circling roots Plastic (shown above), metal, or fabric containers with holes in the sides reduce incidence of circling roots Air dries the media on the outside edge of the root ball preventing root growth there There are several manufacturers of these specially designed containers

One-sided root system from high container temperatures: 

One-sided root system from high container temperatures High temperatures within the container caused root death Few roots are able to grow on the hot side of the container Trees can become unstable after planting into the landscape

Topics covered in this presentation: 

Topics covered in this presentation Introduction to tree root growth Root growth in containers Root growth in field grown trees Root growth in fabric bags

Root growth in a field nursery : 

Root growth in a field nursery Roots will extend twice to three times the edge of the branch tips on many trees unless manipulated by cultural practices Root growth can be manipulated by genetics, irrigation, fertilization, and root pruning The next series of slides illustrates the impacts of these cultural practices on the quality of the root system inside the root ball of field grown trees

Field grown trees should be lifted by the root ball : 

Field grown trees should be lifted by the root ball Moving field grown trees into the landscape requires machinery Trees are gently lifted by straps or ropes secured to the root ball as shown here Lifting by the trunk can result in trunk damage that will cause severe injury to or kill the tree

Root system on a field grown tree : 

Root system on a field grown tree Once dug, field grown trees have a reduced root system compared to when they were growing in the nursery Appropriate irrigation must be applied to maintain health

Root systems vary: 

Root systems vary Roots systems vary from one tree to the next and from one soil type to the next These oak trees were grown from acorns The roots of the tree on the left were more dense than the one on the right Cutting propagated trees of oaks and perhaps other trees have more uniform root systems

Root density differences due to nursery irrigation: 

Root density differences due to nursery irrigation Oak root systems on the left were from trees that were not irrigated during nursery production Those in the middle received irrigation only on the soil that was to become the root ball Those on the right received the same volume of irrigation as those in the center but water was applied to a three foot diameter circle around the trunk Trees in the center had the most fine roots in the root ball

Root pruning field grown trees: 

Root pruning field grown trees Root pruning can increase root density in the root ball Pruning roots on two sides of the tree as shown above can ensure that the tree will not fall over should a storm strike after pruning

Sample root pruning protocol for nursery production: 

Sample root pruning protocol for nursery production Spade root pruning was accomplished by slicing a square tipped balling shovel 36 cm (14 in) long into the soil at an angle similar to that of a mechanical tree spade North and South one-eigth circumference segments (12.5 percent of circumference each, totaling 25% circumference) were pruned in April 1999 20 cm (8 in) from the trunk and East and West one-eigth segments were root pruned in May Root pruning was repeated in August (NW and SE segments) and September (NE and SW segments) 27 cm (11 in) from the trunk The bottom of the hand spade did not reach far enough into the soil to overlap adjacent slices so any roots growing directly down under the trunk were not cut

Root pruning increases root density in the root ball: 

Root pruning increases root density in the root ball Root pruning can increase root density in the root ball and can help prepare the tree for survival in the landscape More small diameter roots and fewer large diameter roots result from root pruning This has been shown (Watson and Gilman) to increase transplant success compared to non-root pruned trees and compared to trees grown in containers

Trees are dug with a variety of machines: 

Trees are dug with a variety of machines A 32-inch tree spade is mounted on the front of this skid-steer vehicle

Digging the tree: 

Digging the tree The spade blades sink into the soil cutting all roots prior to lifting; then the tree is lifted with the spade

Materials needed to secure the root ball of a field grown tree: 

Materials needed to secure the root ball of a field grown tree A black sleeve of woven ground cloth manufactured to fit the outside of the wire basket is slipped over the basket Strapping or rope is secured to the wire basket and the basket is lowered into the hole dug by the tree spade Then the treated or untreated burlap is placed inside the wire basket

Tree is lowered into the basket: 

Tree is lowered into the basket After the treated or untreated burlap is placed inside the wire basket, the tree is lowered into the basket

Burlap is secured tightly around the root ball: 

Burlap is secured tightly around the root ball The burlap is pulled tight and pinned into place

Wire basket is tightened: 

Wire basket is tightened Various devices are used to bend the wire so the basket is firmly securing the soil in the root ball You do not want any movement of the soil and roots during handling and shipping

Finished root ball: 

Finished root ball This finished root ball has black woven cloth on the outside, burlap inside the wire basket, white string securing the five basket loops, and green rope tied to the basket for lifting

Irrigate fresh dug trees regularly: 

Irrigate fresh dug trees regularly Freshly dug trees in the warmest climates (southern US) require irrigation several times daily Many growers provide water with a low volume mist or spray system as shown here

Finished field grown tree: 

Finished field grown tree This tree is hardened-off and ready for shipping to the landscape A good indication of when the tree is ready for planting into the landscape is when roots have grown through the burlap; this typically takes several weeks to a couple months depending on the time of year The black woven ground cloth must be removed (as shown) before planting

Hardened-off field grown tree: 

Hardened-off field grown tree Notice the white root tips growing through the burlap; this indicates that the tree has survived the digging process The survival of this tree is now dependant on the irrigation and handling it receives in the landscape A tree with roots growing through the burlap in this fashion is said to be hardened-off

Topics covered in this presentation: 

Topics covered in this presentation Introduction to tree root growth Root growth in containers Root growth in field grown trees Root growth in fabric bags

Root growth in fabric containers : 

Root growth in fabric containers Some nurseries produce trees in fabric containers in field soil The fabric restricts, but does not prevent, roots from growing into the soil outside the fabric container Root balls of field-grown trees are similar to those grown in fabric containers except that the fabric container root ball is smaller Applying irrigation and fertilizer only to the top of the root ball can help increase roots in the ball compared to applying it to a larger area around the container

Tree in fabric container just dug from the field: 

Tree in fabric container just dug from the field Fabric containers can be used in the ground or above ground When used above ground roots remain mostly in the bag except for those that grow through the fabric at the bottom When used in the ground (as illustrated here), roots grow outside the fabric but they are mostly girdled by the fabric which prevents them from getting too large; roots outside the fabric and the bag are removed from the tree when the tree is harvested

Tree in a fabric container: 

Tree in a fabric container Fabric container (arrow) keeps many of the large diameter roots inside the bag Small roots are located inside and outside the bag This oak tree has circling roots close to the trunk as a result of growing in a smaller container for too long

Tree in a different fabric container : 

Tree in a different fabric container This is a fabric container from a different manufacturer Many roots are shown growing through the fabric and into the soil outside the fabric container This is normal and is to be expected in this type of production system

Roots passing through fabric: 

Roots passing through fabric Roots branch as they pass through the fabric container The fabric is designed to girdle large roots so they do not become large on the outside of the fabric Note how the one large diameter root branched to become many smaller diameter roots on the outside of the fabric

Removing the fabric: 

Removing the fabric The fabric must be removed before stepping the tree up to a larger plastic container or before planting into the landscape Remove the fabric with a sharp implement such as a utility knife or sharp pruning tool Disturb the root ball as little as possible so roots remain more or less intact with the soil

Finished crop in fabric containers: 

Finished crop in fabric containers Do not allow trees to grow too large in the fabric containers as shown here; the root ball is way too small to support this large top (note the dead tree on the left) Appropriately sized trees handled correctly have no problem surviving the digging process from in-ground fabric containers However, taking freshly dug trees directly to the landscape almost never works because irrigation cannot be managed correctly

Summary: 

Summary There are many methods of producing trees Many of them work well, and growers have chosen to use those they are most comfortably with Choose or devise a system that minimizes root defects

Tree Roots in the Nursery: 

Tree Roots in the Nursery By Edward F. Gilman, professor Department of Environmental Horticulture University of Florida http://hort.ufl.edu/woody/planting